Sheet 02
Laser cutting
Flat parts cut from your DXF or from a drawing we redraw for you, nested to keep the offcut down.
- Material
- Mild, stainless, alloy
- Capacity
- 3000 × 1500 mm
- Issued by
- Ardmore Metalworks
The process
What we hold to on this.
The fibre laser runs a 3000 by 1500 bed and cuts mild steel to 16 mm, stainless to 10 mm and alloy to 8 mm. Parts come off it square and clean enough to fold without dressing.
Send a DXF and we nest it as it is. Send a PDF or a sketch and we redraw it, send the drawing back for you to check, and cut nothing until you have signed it off. You are quoted off the actual nest rather than a rate per part.
How it runs
Drawing to quote to first-off inspection.
- 01
Send the drawing
DXF or PDF. If it needs redrawing for nesting we will redraw it and send it back for you to check.
Same day
- 02
Quote off the nested sheet
Priced from the actual nest, not an estimate per part.
2 working days
- 03
First-off inspection
First part gets checked against the drawing before the run continues.
- Address
- 6B Kelvin Road, Papakura, Auckland 2110
- Hours
- Monday to Thursday6.30am – 4.30pmFriday6.30am – 2pm
- Delivering to
- Auckland, Waikato, Bay of Plenty