Sheet 02
Stainless fabrication
Benches, canopies, shelving and splashbacks for commercial kitchens, finished to food-grade standard.
- Material
- 304 and 316
- Capacity
- Benches to 3 m
- Issued by
- Ardmore Metalworks
The process
What we hold to on this.
Benches, canopies, shelving and splashbacks for commercial kitchens, made in 304 for dry work and 316 where there is salt or chlorine. Welds are purged, ground back and grained so there is nothing for food to sit in.
We measure on site before we cut, and we deliver and install ourselves rather than freighting a bench and hoping. A kitchen fit-out is usually four to six weeks from the site measure.
How it runs
Drawing to quote to first-off inspection.
- 01
Send the drawing
DXF or PDF. If it needs redrawing for nesting we will redraw it and send it back for you to check.
Same day
- 02
Quote off the nested sheet
Priced from the actual nest, not an estimate per part.
2 working days
- 03
First-off inspection
First part gets checked against the drawing before the run continues.
- Address
- 6B Kelvin Road, Papakura, Auckland 2110
- Hours
- Monday to Thursday6.30am – 4.30pmFriday6.30am – 2pm
- Delivering to
- Auckland, Waikato, Bay of Plenty